What to do if my Homelite UT43102 motor runs but the chain does not cut?
If the motor of your Homelite Chainsaw runs, but the chain rotates without cutting, the chain might be dull. Try sharpening the chain. Another possibility is that the chain is on backwards, so reverse the direction of the chain.
What to do if Homelite UT43102 motor runs, but the chain is not rotating?
If the motor of your Homelite Chainsaw runs, but the chain is not rotating, it could be because the chain tension is too tight. Retension the chain, check the section on adjusting chain tension. For additional troubleshooting, check the section on replacing the bar and chain. Inspect the guide bar and chain for any signs of damage.
Why is my Homelite Chainsaw bar and chain running hot and smoking?
If the bar and chain of your Homelite Chainsaw are running hot and smoking, it could be due to a few reasons. First, the chain might be too tight, so tension the chain, referring to the section on adjusting chain tension. Also, ensure that the chain oil tank is not empty. Another possibility is that the chain is too tight or that the chain oil tank is empty.
How to fix a Homelite UT43102 Chainsaw chain tensioning dial that is difficult to turn?
If you find the chain tensioning dial on your Homelite Chainsaw difficult to turn, try raising the tip of the guide bar while rotating the tension adjustment dial. It may also be that the clutch cover lock knob is too tight. Press in the clutch cover lock knob and rotate counterclockwise to slightly loosen the clutch cover before attempting to adjust chain tension.
To Next Page
General