Homelite UT60526 User Manual

12 - English
MAINTENANCE
PREPARING FOR USE AFTER STORAGE
The following steps should be taken before using the cultiva-
tor after it has been stored.
 Unfold the handles into the upright position and secure by
tightening handlebar knobs. Do not allow throttle cable
to become pinched when raising the handlebar.
 Pull the starter cord three or four times to clean lubricant
from the combustion chamber.
 Remove spark plug from the cylinder. Wipe lubricant from
the spark plug and return it to the cylinder.
 Reconnect spark plug wire.
 Follow the steps on pages 8-10 to refuel and restart the
cultivator.
HIGH ALTITUDE ENGINE OPERATION
Please have an authorized service center adjust this engine
if it is to be run above 2000 feet. Failure to do so may result
in poor engine performance and increased emissions. An
engine adjusted for high altitudes can not be run at 2000
feet or lower. In doing so, the engine will overheat and cause
serious engine damage. Please have an authorized service
center restore high altitude modified engines to the original
factory specification before operating below 2000 feet.
Spark Plug:
 Disconnect spark plug wire and remove the spark plug. Pour
a teaspoon of clean, air-cooled, 2-cycle lubricant through
the spark-plug hole into the combustion chamber.
 Leaving the spark plug out, pull the starter cord two or three
times to coat the inside of the cylinder wall.
 Inspect spark plug and clean or replace, as necessary.
 Reinstall the spark plug, but leave the spark plug wire dis-
connected.
Air Filter:
 Clean the air filter as previously described.
Cultivator Body:
 Clean dirt, grass, and other materials from the entire unit.
 Wipe the tines with lubricant or spray them with silicone
lubricant to prevent rusting.
 Oil the throttle cable and all visible moving parts. Do not
remove the engine cover.
 Order new parts to replace any that are badly worn or broken.
 Store in an upright position in a clean, dry place. Store with
the handles in the extended position, or loosen handle knobs
and fold handles down. Do not allow throttle cable to become
pinched when lowering the handlebar.
 Properly dispose of any leftover fuel in compliance with
Federal, state. and local laws.
EMISSIONS MAINTENANCE SCHEDULE AND WARRANTED PARTS LIST
Emissions Parts Inspect Before Clean Every Replace Every Clean Every
Each Use 5 Hours 25 Hours or Yearly 50 Hours or Yearly
AIR FILTER ASSY
INCLUDES:
FILTER ................................................................................ X ........................................... X
SPARK SCREEN ................................................................................................................................................................X
CARBURETOR ASSY
INCLUDES:
HEAT DAM ............................... X
GASKETS ................................. X
FUEL TANK ASSY
INCLUDES:
FUEL LINES ............................. X
FUEL CAP ................................ X
FUEL FILTER ............................ X
IGNITION ASSY
INCLUDES:
SPARK PLUG .................................................................................................................................................................X
ALL EMISSIONS-RELATED PARTS ARE WARRANTED FOR TWO YEARS, OR FOR THE PERIOD OF TIME PRIOR TO THE PARTS’ FIRST
SCHEDULED REPLACEMENT, WHICHEVER COMES FIRST.

Homelite UT60526 Specifications

General

Brand	Homelite
Model	UT60526
Category	Tiller
Language	English