Why is the rice from my Homemaker MY-12LS605A Electric Pressure Cooker half cooked or too hard?
If the rice from your Homemaker Electric Pressure Cooker is coming out half-cooked or too hard, it could be because: * Too little water was added; try adding more water. * The cover was opened prematurely; after the cooking time is up, release steam and wait 5 minutes before opening the cover.
Why is the rice from my Homemaker MY-12LS605A too soft?
If the rice from your Homemaker Electric Pressure Cooker is too soft, it's likely because too much water was added. Try reducing the water level in your next batch.
Why is my Homemaker MY-12LS605A leaking from the cover?
Leakage from the cover of your Homemaker Electric Pressure Cooker can occur due to several reasons: * The gasket may be missing; ensure the gasket is correctly placed. * Food particles might be stuck to the gasket; clean the gasket ring thoroughly. * The gasket may be worn out; replace it with a new one. * The cover might not be closed properly; try closing the cover firmly again.
What to do if I can't open the cover of my Homemaker MY-12LS605A Electric Pressure Cooker?
If you're having trouble opening the cover of your Homemaker Electric Pressure Cooker, it could be due to: * The float valve failing to fall after steam release; try pressing the float valve lightly with chopsticks. * Remaining pressure inside the cooker; wait until the pressure lowers down before attempting to open the cover.
Why is it so hard to close the cover of my Homemaker MY-12LS605A?
If you're finding it difficult to close the cover of your Homemaker Electric Pressure Cooker, it might be because: * The gasket isn't positioned correctly; make sure to locate the gasket well. * The push rod is jammed by the float valve; try pushing the push rod lightly with your hand.
Why is my Homemaker Electric Pressure Cooker leaking from the float valve?
If your Homemaker Electric Pressure Cooker is leaking from the float valve, it could be due to: * Food particles attached to the float valve gasket ring; clean the float valve gasket. * A worn float valve gasket ring; replace the float valve gasket.
What to do if all the lamps are flashing on my Homemaker Electric Pressure Cooker?
If all the lamps are flashing on your Homemaker Electric Pressure Cooker, the manual suggests the following possible causes: * The temperature is too high because there is no water inside the inner pot; add water as required. * The temperature is too high because the inner pot is not placed; put the inner pot properly.
Why is the float valve on my Homemaker Electric Pressure Cooker not rising?
If the float valve on your Homemaker Electric Pressure Cooker isn't rising, it might be due to too little food and water inside the pot. Ensure you are putting food and water according to the recommended guidelines.
What to do if exhaustion from exhaust valve does not stop on my Homemaker MY-12LS605A?
If the exhaustion from the exhaust valve on your Homemaker Electric Pressure Cooker doesn't stop, ensure the exhaust valve is in the sealing position. Slide the exhaust valve to the sealing position.
Why is the lamp not bright on my Homemaker MY-12LS605A Electric Pressure Cooker after powering it on?
If the lamp isn't bright after powering on your Homemaker Electric Pressure Cooker, please inspect the socket for bad contact.
Provides an overview of the main functions and operating modes.
Details how to set the 24-hour preset cooking timer.
General| Capacity | 6 liters |
|---|---|
| Power | 1000 watts |
| Material | Stainless steel |
| Number of Programs | 12 |
| Safety Features | Overheat protection, Pressure control, Lid lock |
| Voltage | 220-240V |
| Frequency | 50/60Hz |
To Next Page