User Manual
Page 12 of 43
Step 3
Press Simple Connect for two seconds on
HomePlug Y. After you release the button, the
Power LED will blink. If the Power LED did
not blink, press Simple Connect again for
two seconds.
Make sure to press Simple Connect on
HomePlug Y within two minutes after you
press Simple Connect on HomePlug X.
The LEDs on both devices will switch off and
on twice to signify that they are searching for
another device to pair with.
Note:
Note:Note:
Note: Do not press Simple Connect for more than 2
seconds
Step 4
To confirm if the connection was established,
check the LEDs. The Power LEDs and the
Powerline Activity LEDs on both HomePlugs
are on.
To Next Page
Loading...