Homeright PaintStick Instruction Sheet

1. Grasp clear tube firmly and turn handle counterclockwise to unscrew.
Remove piston from clear outer tube. NOTE: If paint is on the piston
remove paint with a damp rag.
2. Take off and discard old quad-rings. Install new quad-rings and
lubricate with petroleum jelly.
3. Insert inner handle into outer handle and push together. Be careful not
to pinch o-rings. To reassemble, hold the tube securely and turn the
handle clockwise until secure.
PaintStick EZ-Twist Piston
1. Separate inner and outer handles by quickly pulling apart. If you
cannot separate, set PaintStick on floor, put your foot on collar and
roll to loosen.
2. Take off and discard old o-rings. Install new o-rings and lubricate with
petroleum jelly.
3. Insert inner handle into outer handle and push together. Be careful not
to pinch o-rings.
PaintStick Piston
1. Pop out retainer with a screwdriver. Remove foam wiper and pry out
valve.
2. Discard old parts. Clean area. Install new valve and wiper. Press in
retainer.
3. Put a small amount of petroleum jelly into the fill port to lubricate the
foam wiper.
PaintStick & PaintStick EZ-Twist Valve Body
PaintStick
®
& PaintStick
®
EZ-Twist
®
Tune-up Kit Instruction Sheet

Homeright PaintStick Specifications

General

Brand	HomeRight
Model	PaintStick
Application	Interior and exterior painting
Material	Plastic
Power Source	Manual