HomeSaver Mantel Shield User Manual

MANTEL SHIELD
INSTALLATION INSTRUCTIONS
The normal clearance for single-wall stovepipe to a combustible mantel is 18". The normal
clearance from an unlisted stove or insert to a combustible mantel is 36". The mantel shield
allows you to reduce clearances to 9" for stovepipe and 18" for a stove or insert per NFPA 211
standard and the International Residential Code.
Kit Contains:
1 Mantel Shield
4 #10 1
1
⁄ 2 " Phillips Screws
4 Ceramic Spacers
Tools Needed:
Drill
1
⁄ 8 " Drill Bit
Phillips Screwdriver
Tin Snips or Offset Shears
Installation Tips:
1. Make certain that the Mantel Shield extends to the far rear of the mantel so the entire
mantel is protected.
2. To alter the face pitch, carefully bend the Mantel Shield.
3. The Mantel Shield can be cut to length if desired. If cutting, it will be necessary to drill new
screw holes in the Shield.
Instructions:
1. Place the Mantel Shield under the mantel making sure the entire mantel is protected and
mark on the mantel where your first screw hole should be drilled.
2. Using a
1
⁄ 8 " drill bit, drill the first
hole. Insert a screw through the
Mantel Shield and a ceramic
spacer, and into the hole. Tighten
the screw.
3. Then use another hole in the
Mantel Shield as a pilot to drill a
second hole in the mantel. Fasten with a screw and spacer. Continue drilling holes and
fastening screws one at a time.
4. Tighten all screws.
Mantel
Mantel Shield
Ceramic
Spacers
Toll-Free 1-866-667-8454
NorthlineExpress.com
www.NorthlineExpress.com

HomeSaver Mantel Shield Specifications

General

Brand	HomeSaver
Model	Mantel Shield
Category	Fireplace Accessories
Language	English

Summary

Installation Tips

Ensure Full Mantel Coverage

Ensure the Mantel Shield extends to the far rear of the mantel for complete protection.

Adjust Mantel Shield Pitch

Carefully bend the Mantel Shield to alter the face pitch as needed.

Modify Mantel Shield Length

Cut the Mantel Shield to length if necessary, drilling new screw holes.

Installation Instructions

Position and Mark First Hole

Place the Mantel Shield, ensure coverage, and mark the first screw hole location.

Drill and Secure First Screw

Drill the first hole with a 1/8" bit, then insert a screw with a ceramic spacer.

Drill and Secure Remaining Screws

Use subsequent holes as pilots to drill and fasten remaining screws with spacers.

Final Screw Tightening

Ensure all previously fastened screws are securely tightened.