HomeTech EF451 - OPERATING INSTRUCTIONS; Manual Operation; Remote Operation; SAFETY FEATURES

Instructions for Use
• The appliance can be operated either by the switches located on the top right hand side of the fire
or by supplied remote control.
Manual Operation
• The switches located at the top right hand side of the fire. The standby switch must be first switch
on.
• Press once the button
to turn on the appliance and fire effect. A red indicator light will
appear to indicate that the function is ON. Press the button
for 3 seconds this will operate
the dimmer mode.
• Press once the button
for the low heat settings (750W); press twice to switch off the heat
setting.
• Press once the button
for the high heat settings (1500W); press twice to switch off the heat
setting.
Remote Operation
• The standby switch located at the top right hand side of the fire must be first switch on.
• It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more
than once within two seconds for correct operation.
• Press once the button
on the remote control this turns ON/OFF the appliance and fire
effect.
• Press once the button
for the low heat settings (750W); press twice to switch off the heat
setting.
• Press once the button
for the high heat settings (1500W); press twice to switch off the heat
setting.
• Press the button
to operate the dimmer mode.
Safety Cut-Off
• This appliance is fitted with a safety cut-off which will operate if the fire overheats (eg. due to
blocked air vents). For safety reasons, the fireplace will NOT automatically reset.
• To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect the supply to the mains and switch on the appliance.
Symptom
Solution
No operation/ no fan.
Check for safety cut-off operation.
No fire effect light.
Check the bulb by replacement.
TROUBLESHOOTING
OPERATING INSTRUCTIONS
SAFETY FEATURES