Homewerks Worldwide AQUA VISTA 10SHO1H-CH-AV User Manual

11-27-2019Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • HomewerksWW.com
TUB AND SHOWER FAUCET
10SHO1H-CH-AV – Polished chrome nish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
QUANTITY
A
B
C
D
E
G
F
H
A Shower head
1
B Shower arm
1
C Shower arm ange
1
D Hot handle assembly
1
E Cold handle assembly
1
F Tub spout with diverter
1
G Handle anges 2
H Valve body
1
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
CAUTION
• If you solder the joints during installation, the seats, cartridges, and washers
must be removed before using a ame or the warranty will be voided on
these parts.
• Cover the drain to avoid losing parts.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package and hardware contents list. If any part is missing or damaged,
do not attempt to assemble the product. Contact customer service for
replacement parts.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): adjustable wrench, thread sealant
tape, strap wrench, Phillips head screwdriver, silicone
Installation may vary depending on how the previous tub and/or shower faucets
were installed. Supplies necessary for the installation of the product are not all
included; however, they are available wherever plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn on
the old faucet to release built-up pressure. When installing the new tub and/or
shower faucets, hand tighten the connector nuts. DO NOT OVERTIGHTEN.
Connections that are too tight will reduce the integrity of the system.
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 am to 4:30 pm CST) for additional assistance or service.

Homewerks Worldwide AQUA VISTA 10SHO1H-CH-AV Specifications

General

Product Type	Showerhead
Finish	Chrome
Flow Rate	2.5 GPM
Spray Pattern	Full Spray
Material	Metal
Installation Type	Wall Mounted

Summary

Safety Information

Safety Warnings

Protect eyes with safety glasses when cutting or soldering water supply lines.

Installation Cautions

Remove seats, cartridges, and washers before using a flame to avoid voiding warranty.

Preparation

Product Specifications

Assembly Instructions

Initial Setup & Valve Installation

Turn off water, disconnect supply, remove old faucet, verify wall hole sizes for valve body.

Tub & Shower Outlet Preparation

Prepare shower outlet hose and water inlet holes with specified dimensions.

Cartridge Handling and Installation

Do not disassemble cartridges; insert with slot pointed outward for proper operation.

Install Supply Connections

Wrap valve body threads with sealant tape, connect waterline, ensure 'UP' marking is upward.

Install Tub and Shower Outlet Connections

Wrap pipe threads with sealant tape, connect shower/tub outlet pipes and elbows.

Flush Outlets and Check for Leaks

Turn water supply on, flush lines from tub spout until clear, check all connections.

Showerhead Installation

Insert shower arm through flange, wrap with tape, install into wall elbow, attach shower head.

Tub Spout Installation

Wrap spout pipe threads with tape, connect to lower elbow, tighten, and thread spout onto connection.

Handle Installation

Position flanges and handles, secure with screws, ensure correct hot/cold placement, insert index buttons.

Operating Instructions

Care and Maintenance

Troubleshooting

Replacement Parts

Limited Lifetime Warranty