Indoor/Outdoor
Utility Shower Kit
12-2021
PACKAGE AND HARDWARE CONTENTS
MODELS
3070-252-CH-B-WS - Chrome nish
3070-252-BN-B-WS - Brushed nickel nish
3070-252-MB-B-WS - Matte black nish
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • Homewerks.com
PREPARATION
SAFETY INFORMATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product. Contact
customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Recommended for Assembly (not included): Adjustable Wrench,
Drill, Drill Bits, Slip Joint Pliers, Pipe Wrench, Phillips Screwdriver, Pipe
Compound.
Installation may vary depending on how the previous shower was
installed. Supplies necessary for the installation of the shower are not
all included; however, they are available wherever plumbing supplies
are sold.
Prior to beginning installation, turn off the hot and cold water lines, then
turn on the old shower to release built-up pressure. When installing the
new showerhead, hand tighten the connector nuts. DO NOT
OVERTIGHTEN. Connections that are too tight will reduce the integrity of
the system.
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
CAUTION
• If you solder the joints during installation of the shower, the seats,
cartridges, and washers must be removed before using a ame
or the warranty will be voided on these parts.
• Cover the drain to avoid losing parts.
PART DESCRIPTION QUANTITY
A Showerhead 1
B Shower arm 1
C Soap dish 1
D Mounting screw 4
E Faucet body 1
F Drywall anchor 4
G Thread seal tape 1
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 a.m. to 4:30 p.m. CST) for additional assistance or service.
F
A
B
D
C
E
G
To Next Page
Need help?
General