7.
Install the new bulb
in
the socket.
8.
Push the socket into the light
assembly and turn it clockwise
until it locks.
9.
Test
the lights to make sure the
new bulb is working.
lO.Install the trunk lining and secure
it with the fasteners. To reinstall a
fastener, reset the fastener by
pushing on the pointed end until it
pops back almost flush with the
fingers on the housing.
Put the
fastener
in
the hole of the trunk
lining and push on the center until
it locks (the center is flush with
the head).
Lights
Maintenance
199
To Next Page
