When the coolant stops draining,
tightenthedrainplugatthe
bottom of the radiator.
Tighten the drain bolt at the rear
of the engine cylinder block
securely.
Tightening torque:
Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
Install a rubber hose on the drain
bolt in the back of the engine
block. Loosen the drain bolt.
6.
4. 5.
7.
Cooling System
Maintenance
290
DRAIN BOLT
RESERVE TANK
HOLDER
RESERVE
TANK CAP
7 lbf·ft (10 N·m , 1.0 kgf·m)
To Next Page