−
−
−
Turning the
switch to the ‘‘ ’’ position turns
on the parking lights, taillights, side-
marker lights, and rear license plate
lights.
Push down on the
lever to signal a left turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Turn signal
Off
Parking and interior lights
Headlights
High beams
Flashhighbeams
Turning the switch to the ‘‘ ’’
position turns on the headlights.
If you leave the lights on with the
key removed from the ignition
switch, you will hear a reminder
chime when you open the driver’s
door.
Push the lever
forward until you hear a click to turn
on the high beams. The blue high
beam indicator will come on (see
page ). Pull the lever back to
return to the low beams.
To flash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
When the light switch is in the
‘‘ ’’ or ‘‘ ’’ position, the
lights on indicator comes on as a
reminder. This indicator stays on if
you leave the light switch on and
turn the ignition switch to the
ACCESSORY (I) or LOCK (0)
position.
1.
2.
3.
4.
5.
6.
60
Headlights On
Turn Signal
High Beams
Turn Signal and Headlights
Instruments and Controls
69
０５／０７／２７ １５：３８：５６ ３１ＳＤＰ６３０ ００７２
To Next Page
Loading...
Need help?
General
