Remove the electrical connector
from the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Reinstall the rubber weather seal.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Push the electrical connector onto
the new bulb.
(Driver’s side)
Install the front end of the air
intake duct. The front parking/turn signal light
is next to the headlight bulb. On
the driver’s side, remove the front
end of the air intake duct by
pulling it out (see page ).
1.
2.
3.
4.
5.
6.
7.
8.
2.
179
Replacing a Front Parking/Turn
Signal Light Bulb
Lights
180
０５／０９／１３ ２０：０４：０９ ３１ＳＣＶ６３０ ０１８５
To Next Page
Loading...
