CONTINUED
Make sure there are no objects
near the anchors that could
prevent a secure connection
between the child seat and the
anchors.
To install a LATCH-compatible child
seat:
Place the child seat on the vehicle
seat, then attach the seat to the
lower anchors according to the
child seat maker’s instructions.Remove both anchor covers by
pulling forward.
Some LATCH-compatible seats
have a rigid-type connector as
shown above.
Your vehicle is equipped with
LATCH (lower anchors and tethers
for children) in the rear seats. The
lower anchors are located between
the seat-back and seat bottom, and
aretobeusedonlywithachildseat
designed for use with LATCH. The
location of each lower anchor is
marked with a small button above
the point.
1.
2.
3.
Installing a Child Seat
Installing a Child Seat with
LATCH
Driver and Passenger Saf ety
39
MARKS
ANCHOR COVER
Rigid-type
０５／０９／１３ １９：４５：３６ ３１ＳＣＶ６３０ ００４４
To Next Page
Loading...
