Honda 2008 Pilot Navigation System Installation Instructions

2 of 6 All 37152 (0706) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.
5601020Y
5412041B
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
10 mm Combination wrench
Ratchet
10 mm Socket
ILLUSTRATION OF THE COMPONENTS ON
THE CAR
METER PANEL
SELF-TAPPING
SCREWS
2 CLIPS
4. Remove the meter sub panel (three clips).
3 CLIPS
METER SUB
PANEL
AUDIO PANEL
5804570Y
AUDIO UNIT
BUS
CABLE
CASSETTE
PLAYER
5804580Y
AUDIO UNIT
MP3
PLAYER
BUS
CABLE
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers”.
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the meter panel (two self-tapping screws
and two clips).

Honda 2008 Pilot Navigation System Specifications

General

Brand	Honda
Model	2008 Pilot Navigation System
Category	Automobile
Language	English