Honda Civic Type R 2018 User Manual

CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools,
equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and
you should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this
information applies, contact an authorized Honda automobile dealer.
© 2017 American Honda Motor Co., Inc. – All Rights Reserved Page 1 of 9
Service Bulletin
17-070
August 8, 2017 07127 Version 1
2018 Civic Type R: PDI Information
AFFECTED VEHICLES
Year Model Trim Level
2018 Civic Type R Touring
INTRODUCTION
This bulletin covers the pre-delivery inspection (PDI) of the 2018 Civic Type R. It includes these procedures:
1. Fuel the Vehicle
8. Remove the Front Suspension Height Retainers
2. Remove the Exterior Protective Coatings
9. Install the Front License Plate Holder
3. Install the Fuses
10. Set the Tire Pressures
4. Remove the Interior Protective Coverings
11. Start the TPMS Calibration Process
5. Install the Floor Mats
12. Do the PCM Idle Learn Procedure
6. Check the Battery 13. Install the Shift Lock Release Cover
7. Install the Body Plugs 14. Check/Refresh the SiriusXM
®
Radio Dealer Demo
Service
To do a PDI on the navigation system, be sure to complete S/B 17-071, 2018 Civic Type R: PDI of the Navigation
System.
CLAIM INFORMATION
Reimbursement Time: 1.4 hours
NOTE: This time includes the PDI of the navigation system.

Honda Civic Type R 2018 Specifications

General

Brand	Honda
Model	Civic Type R 2018
Category	Automobile
Language	English

Summary

2018 Civic Type R: PDI Information

Affected Vehicles

Lists the specific vehicle model and trim level covered by the bulletin.

Introduction to PDI Procedures

Outlines the purpose and scope of the pre-delivery inspection for the 2018 Civic Type R.

Claim Information

Details reimbursement time for the pre-delivery inspection process.

PDI Procedures

Before Starting

Reviewing documents and removing PDI items from the vehicle.

Starting the Engine Without the Backup Fuse

Procedure to start the engine when the No. 18 BACKUP fuse is removed.

Jack and Lift Points

Illustrates correct jacking and lifting points to avoid vehicle damage.

Fuel the Vehicle

Instructs on fueling the vehicle with premium gasoline and checking the fuel gauge.

Remove the Exterior Protective Coatings

Details removing protective coatings from the exterior, excluding rear doors.

Install the Fuses

Guides on installing backup and audio fuses removed for shipping.

Remove the Interior Protective Coverings

Specifies removal of interior protective coverings, including the steering wheel.

Install the Floor Mats

Explains how to install floor mats correctly using anchors.

Check the Battery

Describes battery testing requirements and recording the diagnostic code.

Install the Body Plugs

Details the installation of body plugs under the vehicle.

Remove the Front Suspension Height Retainers

Instructs to remove plastic retainers from the front suspension.

Install the Front License Plate Holder

Guides installation of the front license plate holder if required by state.

Set the Tire Pressures

Details setting tire pressures according to the doorjamb label.

Start the TPMS Calibration Process

Explains the indirect TPMS calibration using vehicle speed sensors.

Do the PCM Idle Learn Procedure

Describes the procedure for ensuring a steady engine idle after fuse installation.

Install the Shift Lock Release Cover

Guides the installation of the shift lock release cover.

Check/Refresh the SiriusXM® Radio Dealer Demo Service

Details verifying the dealer demo service activation for SiriusXM radio.