For very short distances, such as freeing the vehicle, you can use the detachable
towing hook that mounts on the anchor in the front bumper.
1. Push the right edge of the cover with your
finger, then remove it.
2. Take the towing hook and the wheel nut
wrench out of the cargo area.
3. Screw the towing hook into the hole, and
tighten it with the wheel nut wrench.
■
Towing Hook
To avoid damage to your vehicle, use the towing
hook for straight, flat ground towing only. Do not
tow at an angle. This hook should not be used to tow
the vehicle onto a flat bed. Do not use it as a tie
down.
Make sure to use the properly-designed and attached
towing equipment.
Do not slip the clutch for a long time to get unstuck.
This may overheat and damage the transmission.
Wheel Nut Wrench
Towing Hook
14CR‑Z‑31SZT6300.book306ページ２０１３年８月８日 木曜日 午後４時５２分
To Next Page
Loading...
Need help?
General
