94 Servicing Your Honda
Wheels
Removal
1. Raise the front wheel off the ground by
placing a maintenance stand or support block
under the engine. Secure the rear of the
motorcycle with tie-down straps.
2. Remove the axle nut (1).
3. Remove the axle shaft (2), wheel, and side
collars.
Avoid depressing the brake lever when the
wheel is off the motorcycle. This will force
the caliper pistons out of the cylinders. The
result will be loss of brake fluid. If this
occurs, the brake system will require service.
See your dealer for this service.
Avoid getting grease, oil, or dirt on the disc or
pad surfaces. Any contamination can cause
poor brake performance or rapid pad wear after
reassembly.
Front Wheel Removal
(1)(2)
(1) axle nut
(2) axle shaft
RIGHT FRONT LEFT FRONT
To Next Page
Loading...
