EasyManuals Logo

Honda CRF450RX 2020 User Manual

Honda CRF450RX 2020
199 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
74 Servicing Your Honda
Clutch System
Check that the clutch lever assembly is
positioned properly (the end of the holder (1) is
aligned with the paint mark (2) on the
handlebar) and the securing bolts are tight.
Check the clutch cable for kinks or signs of
wear. If necessary, have it replaced.
1. Check for smooth clutch lever operation. If
necessary, lubricate the clutch lever pivot bolt
sliding surface with grease and/or clutch cable
with commercially available cable lubricant.
2. Check the clutch cable for deterioration, kinks,
or damage.
Check for smooth clutch lever operation. If
necessary, apply multi-purpose grease to sliding
surface of the clutch cable ends.
1. Release the dust cover (1).
2. Turn the adjuster (2) and remove the clutch
cable (3).
3. Disconnect the clutch cable end from the
clutch lever (4).
4. Thoroughly lubricate the clutch cable end (5)
with multi-purpose grease.
5. Connect the clutch cable end to the lever.
6. Install the clutch cable and turn the adjuster.
7. Remove the clutch cable end adjuster (6).
8. Apply multi-purpose grease to the clutch cable
end adjuster inside surface.
9. Recheck clutch lever freeplay and adjust as
necessary (page 73).
If the clutch lever operation is not smooth, replace
the clutch cable.
Other Inspections
(1) holder
(2) paint mark
Clutch Operation
(1)
(2)
Clutch Cable Lubrication
(1) dust cover (4) clutch lever
(2) adjuster (5) clutch cable end
(3) clutch cable
(1)
(2)
(3) (5) (4)
(6) clutch cable end adjuster
(6)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda CRF450RX 2020 and is the answer not in the manual?

Honda CRF450RX 2020 Specifications

General IconGeneral
Engine Type449cc liquid-cooled single-cylinder four-stroke
Bore x Stroke96.0mm x 62.1mm
Compression Ratio13.5:1
InductionProgrammed Fuel Injection (PGM-FI), 46mm throttle body
IgnitionFull transistorized ignition
Transmission5-speed
Final DriveChain
Front BrakeSingle 260mm disc with twin-piston caliper
Rear BrakeSingle 240mm disc
Front Tire80/100-21
Rear Tire120/80-18
Wheelbase58.3 inches
Seat Height37.8 inches
Ground Clearance12.9 inches
StarterElectric
Trail4.6 inches
Front Suspension49mm inverted fork with rebound and compression damping adjustability; 12.0 inches travel
Rear Suspension12.4 inches of travel
Valve TrainUnicam, four-valve

Related product manuals