STARTING SYSTEM
9-3
STARTING SYSTEM TROUBLESHOOTING (CXS TYPE ONLY)
STARTER MOTOR DOES NOT OPERATE
Replace the blade fuse (page 10-3).
Replace the combination switch (page 10-3).
Replace with a known-good battery.
If the battery runs down again, perform the
CHARGING SYSTEM
TROUBLESHOOTING(page 7-7).
Replace battery positive (+) cable.
Replace the starter solenoid (page 9-10).
Disassemble the starter motor (page 9-10)
and check the each parts (page 9-11).
Check the battery condition.
Check the battery voltage between the
starter motor side positive (+) battery cable
terminal and engine ground.
Check the continuity between BAT terminal
(White) and ST terminal (Black/white) of the
combination switch in the START position
(page 10-19).
Check the fuse in the junction box.
Check the starter solenoid (page 9-11).
Abnormal
Normal
Blown
Not blown
Low voltage
No continuity
Continuity
Normal
Abnormal
Normal
Abnormal
Replace the junction box (page 10-3).
Normal
Check for continuity between the junction box
terminals (page 10-20).
82Z30000.book 3 ページ 2010年6月25日 金曜日 午後5時50分