114
uuOperating the Switches Around the Steering WheeluWipers and Washers
Wipers and Washers
The windshield wipers and washers can be
used when the power switch is in ON (w.
■ MIST
The wipers run at high speed until you release
the lever.
■ Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■ Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
■
Front Wiper/Washer
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
If the wiper stops operating due to any obstacle such
as the build-up of snow, park the vehicle in a safe
place.
Rotate the wiper switch to OFF, and turn the power
switch to ACCESSORY
(q or LOCK (0, then remove
the obstacle.
The wiper motor is equipped with a breaker that may
stop motor operation temporarily to prevent an
overload. Wiper operation will return to normal
within a few minutes, once the circuit has returned to
normal.
Pull to use washer.
MIST
INT: Low speed with
intermittent
OFF
LO: Low speed wipe
HI: High speed wipe
14 FIT EV-31TX96100.book 114 ページ ２０１３年６月６日 木曜日 午後２時３３分
To Next Page
Loading...
Need help?
General
