Honda FR750 - TILING DEPTH ADJUSTMENT

ОРЕНАТІОМ
Tiling Depth Adjustment
The drag bar is used to control the tilling depth, which can be adjusted by
loosening the locking bolt and sliding the drag bar up and down as necessary.
Use the gauge lines and indentations on the drag bar to adjust the tilling depth.
Line up the top of the bar holder with a gauge line, and tighten the locking bolt.
During operation, if the machine jerks forward while tilling, press down on the
handlebars. This will cause the drag bar to dig more deeply into the soil.
AUGE LINE
ere DRAGBAR DRAG BAR
INDENTATION HOLDER
LOCKING BOLT
20