Honda FR750 - Page 32

SERVICING YOUR HONDA TILLER
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete draining.
1. Place a suitable container below the engine to catch the used ail, then
remove the filler cap/dipstick, drain plug and sealing washer.
2. Allow the used oil to drain completely, then reinstall the drain plug and
sealing washer. Tighten the plug securely.
improper disposal of engine oil can be harmful to the environment. If you
change your own oil, please dispose of the used oil properly. Put it in a
sealed container and take it to a recycling center. Do not discard itin a trash
bin or dump it on the ground.
3. With the tiller in a level position, fill to the outer edge of the oil filler hole
with the recommended о! (see page 31).
Oil Capacity: 0.63 US qt (0.60 2, 0.53 Imp ді)
NOTICE
Running the engine with a low oil level can cause engine damage.
4. Screw in the filler cap securely.
ENGINE OIL FILLER
CAP/DIPSTICK
OIL DRAIN BOLT
30