#
Headlight Bulb
1.
Remove the bolts and washers from the
headlight case.
2.
Gently pull the lower end of the headlight
forward and remove the headlight.
3.
Disconnect the connector.
4.
Remove the seat rubber.
5.
Unhook the pin and remove the bulb.
6.
Install a new bulb and parts in the reverse
order of removal.
u Install the seat rubber with its TOP
mark facing up.
7.
Tighten the headlight bolts.
Do not touch the glass surface with your
fingers. If you touch the bulb with your bare
hands, clean it with a cloth moistened with
isopropyl (rubbing) alcohol.
Electrical Trouble u Burned-out Light Bulb
Troubleshooting
79
Continued
Connector
Headlight Bolts
Washers
Seat rubber
TOP
mark
Pin
Bulb
To Next Page