Need help?Do you have a question about the Honda VTX1300S and is the answer not in the manual?
General| Engine Type | 1312cc liquid-cooled 52° V-twin |
|---|---|
| Bore and Stroke | 89.5mm x 104.3mm |
| Compression Ratio | 9.2:1 |
| Induction | Single 38mm constant-velocity carburetor |
| Transmission | Five-speed |
| Final Drive | Shaft |
| Rear Suspension | Dual shocks with five-position spring preload adjustability; 3.9 inches travel |
| Front Brake | Single 336mm disc with twin-piston caliper |
| Front Tire | 140/80-17 |
| Rear Tire | 170/80-15 |
| Ignition | Digital with three-dimensional mapping |
| Front Suspension | 41mm fork |
| Rake | 32.0° |
| Trail | 5.7 inches |
| Wheelbase | 65.8 inches |
Outlines guidelines for performing service procedures correctly and safely.
Outlines recommended maintenance intervals and tasks.
Procedures for inspecting and adjusting valve clearance.
Steps for checking and changing engine oil.
Information on brake fluid and system checks.
How to inspect brake pad wear.
General maintenance for the brake system.
Checks for proper tightening of nuts, bolts, and fasteners.
Steps for removing the carburetor.
Procedures for disassembling and inspecting the carburetor.
Instructions for reassembling the carburetor.
Procedures for replacing coolant and bleeding the system.
Removal, inspection, and installation of the thermostat.
Maintenance and inspection of the radiator and cooling fan.
Inspection, removal, and installation of the water pump.
Detailed steps for removing the engine from the motorcycle.
Procedures for installing the engine back into the motorcycle.
Procedure for testing cylinder compression.
Inspecting and refacing valve seats.
Steps for installing the cylinder head.
Steps for removing the cylinder.
Procedures for removing the piston.
Inspection of the cylinder bore.
Steps for installing the piston into the cylinder.
Procedures for installing the cylinder.
Procedures for clutch disassembly and inspection.
Procedures for separating the crankcase halves.
Removal and inspection of the crankshaft and connecting rods.
Procedures for assembling the crankcase.
Procedures for front wheel removal and installation.
Adjusting the steering bearing pre-load.
Procedures for front fork disassembly and assembly.
Torque values for rear end fasteners.
Procedures for rear wheel removal and installation.
Torque values for hydraulic disc brake fasteners.
Procedures for replacing brake fluid and bleeding the system.
Inspection and replacement of brake pads and discs.
Disassembly and assembly of the front master cylinder.
Service for the rear master cylinder and brake pedal.
Disassembly, inspection, and assembly of the front brake caliper.
Disassembly, inspection, and assembly of the rear brake caliper.
Procedures for testing the battery's condition.
Instructions for charging the motorcycle battery.
Checks for current leakage and voltage in the charging system.
Inspection of spark plugs and ignition coils.
Procedure for checking and adjusting ignition timing.
Removal, disassembly, inspection, and assembly of the starter motor.
Service for the flywheel and starter clutch.
Diagnosing and resolving starting issues.
Diagnosing and resolving issues with engine power loss.
To Next Page
