Need help?Do you have a question about the Honda XR190CT-H 2017 and is the answer not in the manual?
General| Engine Type | Air-cooled, 4-stroke, OHC |
|---|---|
| Displacement | 184.4 cc |
| Compression Ratio | 9.5:1 |
| Fuel System | Carburetor |
| Ignition | CDI |
| Transmission | 5-speed |
| Final Drive | Chain |
| Front Suspension | Telescopic fork |
| Rear Brake | Drum |
| Length | 2, 050 mm |
| Rear Suspension | Mono-shock |
| Front Brake | Disc brake |
| Fuel Capacity | 12 liters |
Important safety precautions and guidelines for servicing the vehicle, emphasizing qualified technicians and potential risks.
Instructions on how to interpret safety messages, symbols, and general information within the manual for effective use.
Provides details on identifying the XR190CT-H model and its destinations based on code/type and visual markers.
Lists general specifications including dimensions, frame, engine, fuel system, drive train, electrical, and suspension details.
Specifies torque values for various fasteners in the sidestand, front wheel, fork, rear suspension, and front brake assemblies.
Lists specialized tools required for specific maintenance procedures related to fuel & engine and frame & chassis components.
Illustrates the routing of main wire harnesses, switch wires, and electrical connectors throughout the motorcycle.
Scheduled maintenance tasks and intervals for the LA type model, detailing inspection, cleaning, adjustment, and replacement items.
Scheduled maintenance tasks and intervals for the U type model, detailing inspection, cleaning, adjustment, and replacement items.
Information and diagrams for installing and servicing body panels like the drive chain cover, mud guard, and engine guard.
Instructions and diagrams for installing the rear carrier and rear carrier base onto the motorcycle's tail section.
Details on the right sidestand installation, including torque specifications, lubrication points, and specific tightening instructions.
Procedures for front wheel disassembly, bearing replacement using special tools, and inspection of components.
Step-by-step instructions for front fork disassembly, oil seal replacement, and fork fluid level adjustment.
Details on the steering stem assembly, including top bridge installation, torque specifications, and related component references.
Instructions for rear suspension component installation, including shock absorber, swingarm pivot, and bearing installation.
Procedures for front brake master cylinder disassembly, maintenance, and inspection, including torque values and tool usage.
Information on the starter motor components, assembly, and electric starter inspection procedures, including diagrams.
Details on the speedometer VS sensor installation and inspection, including lubrication requirements and component identification.
To Next Page