What to do if my Honeywell Home Humidifier is leaking water?
If your Honeywell Home Humidifier is leaking water, there are several potential causes. It could be due to leaking joints, in which case you should shut off the water and tighten the connections. Verify that brass tubing inserts are used. If a saddle valve is used as the shut off valve, verify the rubber pad is installed on the saddle valve.
Why is my Honeywell Home HE240 not producing any humidity?
Low humidity from your Honeywell Home Humidifier can stem from several factors. Make sure the damper blade is set to 'winter' position to allow humidification. Rapid air changes and drafts can also reduce humidity, so keep doors and windows closed, close the fireplace damper when not in use, minimize exhaust fan running time, and seal around doors and windows. If the furnace blower isn't operating, reset the circuit breaker or check for a blown fuse, ensure the furnace power is on, check all external wiring connections and the humidity control setting, verify that the pressure switch tubing isn't pinched or obstructed. If issues persist, consult a professional heating contractor.
What to do if my Honeywell Home HE240 Humidifier has high humidity?
If your Honeywell Home Humidifier is showing high humidity, and you notice condensation on the walls, turn off the humidity control and water until the condensation is completely evaporated. If you observe heavy condensation on the windows, and if the H6062 is set for frost control using an outdoor sensor, and you still get condensation, lower the setting on the H6062.
Why is there no water draining from my Honeywell Home HE240 Humidifier?
If there's no water draining from your Honeywell Home Humidifier, several issues could be the cause. Check the control circuit wiring and all connections for electrical problems. Turn the humidistat up all the way to see if 'Humidity Boost' appears on the screen. Verify that the outlet has power and that the shut off valve is turned on; if it's a saddle valve, ensure the needle pierces the water line and then backs out to open the valve. Also, verify plumbing connections for kinks, remove the humidifier cover to check if water flows into the distribution tray, and ensure there are no obstructions in the drain tubing. After verifying other wiring components, turn on furnace fan, turn humidistat up and down, and listen for solenoid to click.
General| Type | Bypass Humidifier |
|---|---|
| Capacity | 17 gallons per day |
| Installation | Duct-Mounted |
| Dimensions | 14.5 x 12.5 x 10 inches |
| Weight | 9 pounds |
| Power Source | Electric |
| Coverage Area | Up to 2, 000 square feet |
| Mounting | Horizontal or vertical |
Defines terms like WARNING and CAUTION used in safety instructions.
Lists essential safety hazards and precautions before installation and use.
Step-by-step instructions for the physical installation of the humidifier.
Steps to verify the correct functioning of the humidifier after installation.
To Next Page
