3
Power optional RedLINK accessories
3.1 Install batteries in RedLINK accessories.
• Portable Comfort Control
• Wireless Outdoor Sensor
• Wireless Indoor Sensor (Prestige & RedLINK VisionPRO
only)
• Wireless Entry/Exit Remote
• Wireless Vent and Filter Boost Remote
3.2 Connect gateway to internet and
connect to power.
3.2a Connect RedLINK Internet
Gateway to router or modem
with Ethernet cable (RJ45).
3.2b Connect gateway’s power cord to an electrical outlet that
is not controlled by a wall switch.
I
NTER
N
ET
POWER
REDLINK
Performing initial setup
Initial setup options define the type of system you are installing: *
• Residential or commercial (Prestige & RedLINK VisionPRO only)
• Non-zoned or zoned
4.1 Follow prompts on the screen to select appropriate options.
4.2 Link the thermostat to the
equipment interface module.
4.2a Press and quickly release the
CONNECT button on the EIM.
Make sure the “Connected” light
is flashing green.
* RedLINK FocusPRO shows numbers on
the display during setup. Follow install guide
included with that thermostat.
Next
APPLICATION
residential
3
4
To Next Page
Loading...
Need help?
General
