STEP 4: PROGRAM NEW USER CODES
SECURITY NOTE: To insure privacy, this procedure should be repeated for both of
the factory pre-set codes
1. Unlock the safe with the first factory pre-set
(or current active) code.
2. If correct code is entered, “OPEN” will appear on
the LCD panel, and you will hear a chime tone
indicating the safe is unlocked.
3. Immediately enter “” then a new 4-8 digit code
followed by the “#” key. (if you use an 8-digit
code, you will not need to enter the “#” key after.
4. If entered correctly, “IN” will appear on blue
display followed by a chime and the new code
number will appear for 1 second.
Repeat this process to reprogram the second factory pre-set code.
Your new code is now ready to use and the previous code is erased from
memory. If you wish to change your new code, simply repeat the process with
current active user code(s) and enter new code(s).
TO OPEN THE SAFE USING NEW USER CODE(S):
Repeat the process described in STEP 3: UNLOCK AND OPEN SAFE, substituting
the new user code(s) for the factory preset user code(s)
To Next Page
Loading...
Need help?
General