Models 5101 & 5102
Steel Security Safe with Digital Lock
PACKAGE CONTENTS
1 – Steel Security Safe
1 – Operation Manual
2 – Override Access Keys
4 – “AA” Batteries
1 – Mounting Kit w/ Bolts
DO NOT RETURN SAFE TO STORE!
If there are any missing parts or you have
difficulty setting up or operating your safe,
please contact our Consumer Assistance
Department by telephone:
1-877-354-5457
(USA & Canada)
Monday–Friday
7am - 5pm PST
PRODUCT OVERVIEW
A - Safe Entry Knob
B - Override Key Cover
C - Electronic Digital Keypad
D - Safe Cabinet Body
E - Safe Door Assembly
F - Serial Number Label
IMPORTANT
: Remove plastic corners from outside of safe door before operating.
SETUP
STEP 1. OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small screwdriver.
2. Insert override key and turn left to unlock safe.
3. Turn knob to right and open safe door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on inside door.
2. Insert 4 “AA” batteries (included).
3. Replace the battery cover.
4. Do not close door before testing digital lock.
STEP 3. TEST DIGITAL LOCK
1. With door open, turn knob left to put locking door bolts (B) in lock position.
2. Remove override key and store in a secure place. NEVER STORE KEYS INSIDE SAFE!
3. Enter the preset pass code: “1”-“5”–“9”-“b” .
4. Turn knob to right within 5 seconds.
5. Lock bolts should recede into the unlocked position.
STEP 4. PROGRAM A NEW PASSCODE
1. With door open, press red reset button (C) inside door.
2. Yellow light is on, enter new pass code in 30 seconds.
3. Enter personal code (3 to 8 digits) followed by “A” or “B”.
4. Safe will beep and yellow light will turn off.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
OPERATION
TO OPEN THE SAFE
1. To unlock and open safe, enter the pass code followed by “A” or “B”.
2. Turn door entry knob to the right and open door.
TO CLOSE THE SAFE
1. Close the door and hold it in the closed position.
2. Turn door entry knob to left to engage the lock bolts and lock safe.
To Next Page
Loading...
Need help?
General
