Honeywell CARMEL 50197 - Closemount Instructions

10
OPERATING INSTRUCTIONS
Figure 6.3Figure 6.2
Figure 6.1
1. To operate the fan using the remote, press and release the following buttons (Figure 6.1):
Fan Off - Turns the power to fan off.
High Speed - Turns on fan at high speed.
Medium Speed - Turns on fan at medium speed.
Low Speed - Turns on fan at low speed.
Light Control: Turns the light on and off. Press and hold to dim or brighten lights (for dimmable bulbs only).
Light Delay Off mode - Light stays on for 60 seconds to allow for safe exit from room. Tap Light Delay once to activate. Fan
light blinks once to confirm Light Delay is active. Press any button to cancel.
Variable Breeze - Simulates a breeze in nature. Press and hold button to activate. Press any fan speed button to cancel.
Home Shield™ - Simulates occupancy while away from home. Fan remains off and the light randomly turns on for a
minimum of five minutes and a maximum of 20 minutes. The light remains off for 60 minutes between events. Press and
hold button to activate. Light will blink twice to confirm Home Shield is active. Press any button to cancel.
LED Indicator - should illuminate when any remote button is pressed. If not, replace the DC3V, CR2032 batteries.
LEARN Button - Syncs remote to receiver (see TROUBLESHOOTING for instructions). Note: To access LEARN button,
remove battery door from back of the remote using a flat-head screwdriver.
2. If desired, the wall bracket in remote pack can be installed to a wall using the provided mounting screws. The remote can be
stored in the wall bracket for easy access (Figure6.2).
3. Using a ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat setting in winter
without feeling a difference in your comfort. The reverse switch is located on the switch housing (Figure 6.3).
In warmer weather, push the reverse switch left, which will result in downward airflow creating a wind chill effect.
In cooler weather, push the reverse switch right and the fan to low, which will result in upward airflow that can help move
stagnant, hot air off the ceiling area. Important: Wait for the fan to stop before moving the reverse switch located on the light
kit. The reverse switch must be set either completely left or right in order for the fan to function correctly. If the reverse switch
is set in the middle position, the fan will not operate.
Remove glass bowl by turning in a counter
clockwise direction to access the reverse switch.
Reverse Switch
Wall Bracket
Mounting
Screw
A
I
J
E
B F
C G
D H