Honeywell Carnegie - User Manual

Questions and Answers

D
diana52Jul 29, 2025
Why is my Honeywell Carnegie Fan remote control not working?
- L
  Luke AlexanderJul 29, 2025
  If your Honeywell Fan remote control isn't working, try these steps: First, turn off the main power, then turn it back on. Within 30 seconds, press and hold the high and low speed buttons on the remote simultaneously for 5 seconds. The LED indicator will flash 3 times, indicating successful synchronization. The fan should start on low speed with the light off. Also, insert a new 12V battery into the remote's battery compartment. If you have multiple fans nearby, turn off the power to the other fans and re-sync the remote.
J
jthompsonAug 3, 2025
How to fix a Honeywell Fan that does not move?
- S
  sbrownAug 3, 2025
  If your Honeywell Fan isn't moving, try the following: First, firmly push the reverse switch completely to the left or right. Ensure the wall switch is turned on. Next, check the power by turning it on or inspecting the fuse (breaker). As a final step, turn the power off and check all connections at the ceiling outlet box.
C
Christopher GreerAug 9, 2025
Why is my Honeywell Carnegie wobbling excessively?
- J
  Joseph ClayAug 9, 2025
  Excessive wobbling in your Honeywell Fan can often be corrected with a few adjustments. First, check and tighten all screws connecting the fan blades to the blade arms and the blade arms to the motor. You might also try switching one blade with a blade from the opposite side, or use a blade balancing kit to balance the fan. Also, turn off the power, loosen the canopy, and ensure the mounting bracket is securely attached to the electrical outlet box, making sure it's flush and without movement. In some cases, using a longer downrod or moving the fan to a different location might help. Finally, lift the yoke cover and tighten the set screws on the yoke until secure.
P
Patrick JarvisAug 15, 2025
Why is my Honeywell Fan so noisy?
- D
  Dan WellsAug 15, 2025
  A noisy Honeywell Fan can be due to several reasons. Start by checking and tightening all screws that hold the fan blades to the blade arms and the motor. If any blades are cracked, replace them. Avoid using a full range dimmer switch to control the fan speed, as this can cause noise. Make sure the outlet box is securely attached to the building structure. Also, ensure the mounting bracket is securely fastened to the outlet box and that the screws are tight.
A
amanda79Aug 21, 2025
What to do if my Honeywell Carnegie lights are not working?
- R
  Robert CisnerosAug 21, 2025
  If your Honeywell Fan is running but the lights aren't working, first ensure that the single-pin connectors are properly secured. If that doesn't solve the issue, turn off the power and check all connections at the ceiling outlet box.