6
STANDARD OR ANGLE MOUNT INSTALLATION
1. Remove the downrod clip and downrod pin from the downrod. Then partially loosen the set screws in the yoke at the top of the
motor assembly (Figure 3.1).
2. Feed the fan wires and braided cable through the yoke cover, canopy and downrod (Figure 3.2).
3. Slide the downrod into the yoke of the motor assembly. Align holes and reinstall the downrod pin and downrod clip and secure
with the two set screws (Figure 3.3).
4. Depending on the length of downrod you use, you may want to cut the fan wires to simplify wiring. After pulling the wires all
the way through the downrod, measure 8 inches of wire. Cut off the excess wire using wire cutters (not included).WARNING:
Do NOT cut the braided cable. Then, strip 1/2” of insulation from the end of each wire (Figure 3.4).
5. Lift the downrod into the mounting bracket. Rotate the downrod until the tab in the mounting bracket is seated in the slot in
the downrod ball. WARNING: The fan and/or downrod should not rotate in the mounting bracket, if installed correctly. Failure
to align the slot in the downrod ball with the tab on the mounting bracket may result in fan falling causing serious injury or
death. (Figure 3.5).
6. Insert the receiver into the mounting bracket with the flat side facing the ceiling (Figure 3.6).
Figure 3.1
Figure 3.4 Figure 3.5 Figure 3.6
Downrod Clip
Set Screw
Yoke
Downrod
Downrod Pin
Downrod
Canopy
Yoke Cover
Braided Cable
Braided Cable
Figure 3.2 Figure 3.3
8 in.
Downrod
Clip
Downrod
Downrod Pin
Set Screw
Mounting
Bracket
Receiver
Mounting
Bracket
Downrod
Tab
Slot
To Next Page
Loading...
