15
LIGHT KIT INSTALLATION
Fig. 26
Fig. 24
Fig. 25
Switch Housing
Cover Screw
Switch
Housing
Cover
26. Lift the glass globe up to the light kit and twist tightly
in a clockwise direction until it is secure (Fig. 26).
25. Install bulbs (Fig. 25).
Important: When replacing the bulb, allow bulb and
light kit to cool before touching.
24. Connect the two 4-pin connectors and two 9-pin
connectors from the switch housing. Insert the
connectors into the switch housing. Then, install
the switch housing cover to the switch housing
using the switch housing cover screws that were
previously removed (Fig. 24).
Bulb
Switch Housing
Cover Screw
Glass Globe
To Next Page
Loading...
