6 CT45/CT45 XP Mobile Computer Series User Guide
Battery Part Numbers
CT45 Models
CT45 XP Models
Charge the Battery Before Use
The mobile computer ships with a partially charged battery. Charge the battery
with a CT40/CT45 series charging device for a minimum of 3 hours.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
About the USB Type C Connector
You can use a USB cable to charge the mobile computer from a host device (e.g.,
laptop or desktop computer). The connected host device must supply a minimum
power output of 5V, 0.5A to the mobile computer.
Note: If the mobile computer is drawing more current than supplied by the charging source,
charging will not take place.
Model Configuration
x = configuration variations
Battery P/N
CT45-xxx-xxxxxxx 318-055-067
Configuration number (CN) is located on the label in the battery well of the mobile computer.
Model Configuration
x = configuration variations
Battery P/N
CT45P-xxx-xxxxxxx 318-055-067
Configuration number (CN) is located on the label in the battery well of the mobile computer.
Caution: Read Battery Recommendations and Safety Precautions on page 12
and all cautionary markings on the battery, charging peripheral, and
device using the battery before attempting to install, use, or charge
the battery.
To Next Page
Loading...
Need help?
General