Honeywell DT92E Manual

Basic System Operation
Pairing and Clearing the Thermostat
How to Clear the memory :
1. On the Thermostat press and hold the power button for 2 seconds to put the unit into the standby
2. Press the TOP AND DOWN arrow together till you see “Inst” on the screen
3. Now press the down arrow once to go to “C0nt”
4. Press the Up arrow 3 times to get to “Clr” and then press the OFF (power) button.
5. The memory of the Thermostat is now cleared.
How to pair the Thermostat to the Link Plus :
1. Open the Link Plus app, Press the Plus Icon to Add a device, Select “LINK HONEYWELL HOME DEVICE”
2. Give the device a name on the app
3. On the Thermostat press and hold the power button for 2 seconds to put the unit into the standby
4. Press the TOP AND DOWN arrow together till you see “Inst” on the screen (Installer mode).
5. Now press the down arrow once to go to “C0nt”
6. Now press the OFF (power) button on the Wireless Thermostat
7. On the Link Plus app, press the “LINK” Button, the device should pair.

Honeywell DT92E Specifications

General

Display	LCD
Power Supply	2 x AA batteries
Temperature Range	5°C to 35°C
Mounting	Wall-mounted
Switching Current	3 A
Switching Voltage	230 V AC
Backlight	No
Type	Digital Room Thermostat
Compatibility	Heating systems
Dimensions	92 x 92 x 27 mm
Weight	150g
Control Mode	TPI (Time Proportional Integral)