One Fire-Lite Place
Northford, CT 06472-1653 USA
203-484-7161 • FAX 203-484-7118
www.firelite.com
ECC-RM Remote Microphone
Product Installation Document
PN LS10029-000FL-E:B 8/27/2013 13-739
1Overview
The ECC-RM is an optional Remote Microphone
compatible with the ECC-50/100 Emergency Command
Center. ALL CALL paging can be broadcast over the
speaker circuits by depressing the microphone's push-to-
talk switch. The RM requires an external data bus
connection, an external audio riser connection, and an
external operator interface power connection (24 volts
DC) from the ECC-50/100 main console. Refer to the
ECC-50/100 Manual, LS10001-000FL-E, for more
information.
NOTE: Installation and wiring of this device must be
done in accordance with NFPA 72 and local ordinances.
2Installation
2.1 Removing the Bracket/
Microphone Assembly
1. Unlock the cabinet door.
2. Remove the two screws holding the assembly in
place.
3. Remove the bracket/microphone by sliding the
assembly out of its mounting slots.
4. Store assembly in a safe location.
2.2 Mounting the Backbox
1. Mark and predrill two holes for the top and two for
the bottom of the backbox.
2. Hold cabinet on wall and tighten down all fasteners to
complete backbox mounting.
screw holes
Figure 2 Microphone Assembly Screw locations
mounting slots
Figure 3 Removing the Microphone Assembly
To Next Page
Need help?
General