FocusPRO TM TH6110D Programmable Thermostat
Insert finger into wire hole and pull to
remove wallplate from thermostat.
Remove the wallplate @ore the ther-
mostat as shown at left, then fk>llow
directions below for mounting.
1 ]insert quick reference card in slot
in back of thermostat.
2 Pull wires through wire hole.
3 Position wallplate on wall, level and
mark hole positions with pencil.
4 Drill holes at marked positions as
shown below, then tap in supplied
wall anchors.
Insert quick reference card
5 Place wallplate over anchors, insert
and tighten mounting screws.
Drill 3/16" holes for drywall.
Drll 7/32" holes for piaster,
To Next Page
Loading...
