H46D
UMIDIFIER
w-
‘“i’
r
5WL+
E%@
~
F&~~~l~~S;ONNECT
MEAN,
AND
CIVERLOAD PROTECTION
251
IB
FIG. 8—TYPICAL WIRING DIAGRAM FOR H48D USED
WITH A SWITCHING RELAY.
A
&EH”M,D,FIEFI
PLUG
ON
H46E;H”M,D,F,ER PLuG oN
“46,
~7Ci
DEHUMIDIFIER ON H46E;TOH”M,D,F,ERON
Ii,,,.
12,444
FIG.
9-H46E,F
INTERRUPTER PLUG CONNECTIONS.
H46C & E DEHUMIDIFY
CONTROLLERS
The H46C and E switches make contact on a relative
humidity rise to the set point to start the dehumidifier. A
decrease in relative humidity to the set point minus the
differential breaks the switch contact to
stop
the
de-
humidifier.
Turn the control knob clockwise
m
to the setting
stop to put the dehumidifier in the ON position. Set to
the OFF position by turning the control knob counter-
clockwise
n
to the stop.
H46D & F HUMIDITY
CONTROLLERS
The H46D and F switches make contact on a
humidity fall to the set point minus the differential. In
most humidifier systems, the furnace fan must be
operating before the humidifier starts. An increase in
humidity to the set point breaks the switch contacts.
Turn control knob clockwise
n
to the stop for
ON position. Set to the OFF position by turning the
control knob counterclockwise
n
to the stop.
CHECKOUT
Place the system in operation and observe through at
least one complete cycle to make certain that all com-
ponents are functioning properly.
Honeywell Inc.
International Sales Offices in all principal cities of the world. Manufacturing in
1885 Douglas Drive N.
Australia, Canada, Finland, France, Germany, Japan, Mexico, Netherlands,
Spain, Taiwan, United Kingdom, U.S.A.
Im
e
Golden Vallay, MN 55422 -4SS8
PRINTED
IN U.S.A.
QUU2TYLSKEY
To Previous Page
Loading...
Need help?
General
