OSCILLATION FEATURE
DUAL UV LAMP OPERATION
• Press the UV button to turn the Lamps on or off (Fig 7).
• The lamps will light and you will see a faint blue glow along the top of the
unit.This is a visual effect to let you know that the UV feature has been
turned on.The UV bulbs are located inside the product and can’t be seen
during normal operation.
• The UV button will be illuminated on the control panel.
NOTE: Removing the rear grille or turning the unit off will cancel the UV
Lamp function.
To help circulate fresher, cleaner air throughout the room, this unit has an
oscillation feature.
• To turn oscillation on or off, simply press the Oscillation ( ) button
(Fig 6).
Fig. 6
Fig. 7
This model is equipped with long-life HEPA-Type filters.You have the option of
cleaning your HEPA-Type filters or replacing them, depending on your personal
preference.
To Clean Your HEPA-Type Filter:
• Air purifier should be turned off and unplugged prior to cleaning filters.
• Remove the rear grille from the air purifier by pushing down on the release
tab a
t the top of the grille and pulling the grille away from the unit.
• DO NOT USE WATER OR OTHER LIQUIDS TO CLEAN THE HEPA-TYPE FILTER.
• Remove filters from the unit. DO NO
T IMMERSE FILTERS IN WATER.
• It is recommended that you use a vacuum cleaner that has a HEPA filter built into it. If a HEPA filter
vacuum is not available,
you should vacuum your HEPA filter outdoors to keep the particles from getting
recirculated in the air in your home.
• To vacuum-clean the filter,hold the filter and run a vacuum cleaner with a nozzle or brush attachment
along the filter to pick-up the dirt and particles (Fig. 8). Repeat along the entire surface of the HEPA-
Type filter.
• Note:The filter may still be discolored even after vacuum cleaning it.This is acceptable and will not
affect performance.
• After vacuuming the filter, place it securely back into the air purifier housing and snap filter grille into
place.
• Press and hold the “Filters”button to re-set the indicator light.
CLEANING/REPLACING THE HEPA-TYPE FILTERS
Fig. 8
NOTE: If the odor reducing pre-filter is used in lieu of the permanent washable pre-filter, it will
need to be replaced approximately every 3 months.
OPERATION
(CONTINUED)
OPERATION
(CONTINUED)
HHT-149-HD_OM.qxd 3/4/10 9:44 AM Page 5
To Next Page
Loading...
Need help?
General
