6
We recommend that you clean the air purifier at least once every 3 months and before extended storage.
Use only a dry cloth to wipe the external surfaces of the air purifier.
DO NOT USE WATER, WAX POLISH, OR ANY CHEMICAL SOLUTION.
If your Air Purifier will not be used for more than 30 days, we recommend that you:
• Remove the True-HEPA Filters from the unit.
• Wrap the True-HEPA Filters in an air tight plastic bag.
• Remove the Odor Reducing Pre-filter and place it in an air tight plastic bag.
CLEANING AND STORAGE
The odor reducing pre-filter not only helps reduce odors, but also helps capture large airborne particles that
enter the grille. This Pre-Filter should be replaced every 3 months, as it will become covered with particles
and fibers that will reduce filtration performance.
Use the specially designed Type
Household Gas & Odor
Reducing Pre-filter, available where the True HEPA filters are sold and from Kaz at:
www.replacementfilters.com or by calling Kaz Consumer Relations at 1-800-477-0457.
ODOR REDUCING PRE-FILTER MAINTENANCE
REPLACING THE TRUE-HEPA FILTERS
See INSTALLATION INSTRUCTIONS on page 3 of this manual.
You may be able to purchase Honeywell replacement True-HEPA filter
R
for your air purifier at the store
where you purchased your air purifier or they can be ordered directly from Kaz USA, Inc., the licensee of
Honeywell air purifiers at www.replacementfilters.com. If you have any questions, contact Kaz Consumer
Services at 1-800-477-0457.
To RESET Either Electronic Filter Check:
After you have replaced the appropriate filters the “Check Filters or “Check Pre-Filter” light will remain on
until it is reset. With the unit powered off, press the lighted button and hold for approximately 3 seconds
until the light turns off. The electronic filter check is now reset. Depending on individual usage (environment
and hours used), you may need to replace filters more or less frequently.
NOTE: If you change the Pre-Filter or HEPA Filter before the Electronic Filter Check lights are illuminated,
you should still reset the indicator. With the unit plugged in and powered off, press and hold the appropriate
“Filters” or “Pre-Filter” button for 5 seconds. The light will flash red twice to signal that the indicator has
been reset.
These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon
the concentration of contaminants going through the system. High concentrations of contaminants such as
dust, pet dander and smoking will reduce the useful performance of the filter.
NOTE: None of the filters are washable. Do not immerse them in water.
ELECTRONIC FILTER CHANGE REMINDER (continued)
To Next Page
Loading...
Need help?
General
