First look to see if your fan has a cross base or a round
base, and then follow the base assembly instructions for the
fan you have.
FOR CROSS BASE
• Place Base Extensions (A) as illustrated and push down
hard to snap Base Connector (B) firmly onto Base
Extensions (A) (Fig. 1).
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the Base
Connector and push in. Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE 90° until it stops. DO NOT OVER-TIGHTEN
(Fig. 2).
FOR ROUND BASE
• Insert the Metal Pole (C) into the Base by lining up the
recessed slot in the Pole to the raised dot on the inside of
Base and push in (Fig. 3). Be sure that the Pole is fully
seated. Hold the Base firmly and twist the Pole
CLOCKWISE 90˚ until it stops. DO NOT OVER-TIGHTEN
.
To Next Page
Loading...
