EasyManua.ls Logo

Honeywell HWM-950-Medicine Cup - TROUBLE SHOOTING; Power and Indicator Issues; Mist and Water Output Issues; Reset Light and Condensation

Honeywell HWM-950-Medicine Cup
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLE SHOOTING
If your Humidifier is not working properly, refer to the following:
NOTE: FAILURE TO KEEP THIS UNIT CLEAN FROM MINERAL DEPOSITS NORMALLY
CONTAINED IN ANY WATER SUPPLY WILL AFFECT THE EFFICIENCY OF OPERATION
OF THIS UNIT. CUSTOMER FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID
THE WARRANTY.
PROBLEM
Power Switch is set
to “On” and Power
Indicator is off
Little or no mist is
produced
Reset Light illuminated
Water overflows from
Reservoir
Condensation forms
around humidifier
or windows.
POSSIBLE CAUSE
Unit not plugged in
No power at outlet
No water in tank
Unit is not level
Mineral deposits on Heater
or Removable Water Tray
Water Tank was washed
with detergent
Water Tank is empty
Unit not reset after refill
Tank may be leaking
Tank Cap is not tight
Mist Intensity is set too high
for room size or pre-existing
humidity level.
SOLUTION
Plug unit in
Check circuits, fuses,
test outlet.
Fill Water Tank.
Place on a level surface.
Clean Heater and
Removable Water Tray
Rinse thoroughly with
clean water.
Refill Water Tank
Follow Reset Procedure
Check the Tank for leaks
and replace if necessary
Tighten Tank Cap
Decrease mist output to
low or open door to the
room.

Related product manuals