– 33 –
USER FUNCTIONS
USER FUNCTIONSUSER FUNCTIONS
USER FUNCTIONS
Scheduling User Interface
xid
Event Identifier
Event Identifier
Enter a 1-digit schedule action. (x = event identifier)
NOTES: 1. See Table 1 for an explanation of each entry of the event identifier.
2. If “Follow me” reminder telephone number is programmed, the reminder
announcement is also delivered to that number.
3. If “0” is entered, and accepted by deptessing [*], tthe keypad will beep four
times and return to the Schedule Number prompt and the schedule number
will be advanced.
Selections
0 = Empty - no event scheduled (or schedule temporarily disabled).
1 = X10 Device
2 = Latch Key Report
3 = Automatic Stay Arming or Scheduled Stary Arming (LynxSIA Plus)
4 = Reminder Announcements
5 = Alarm Clock
[*] = Accept entry and continue
[#] = Return to previous prompt
xx:Ab
Begin Hour AM
Begin Time (hour)
Enter a two-digit begin hour. (xx = begin hour)
Note: 1. To enter the hour 3, press “0” followed by “3”.
2. When programming schedule number 7 and 8, do not program turn on/off to
occur within the same 1-hour period. This will prevent this random feature from
causing a reversal of the on/off times.
Selections
00 to 12
[*] = Accept entry and continue
[#] = Return to previous prompt
xx:Ab
Begin Hour AM
Begin Time (AM/PM)
Enter a selection for AM or PM. (xx = begin hour)
Selections
0 = AM
1 = PM
[*] = Accept entry and continue
[#] = Return to previous prompt
b:xx
Begin time(min)
Begin Time (minute)
Enter a two-digit schedule begin time (minute) (xx = begin minute)
Selections
00-59 (minute)
[*] = Accept entry and continue
[#] = Return to previous prompt
To Next Page
Loading...
Need help?
General
