Honeywell Miller - WEBBING ADJUSTABLE LANYARD; INSTRUCTIONS FOR USE

WEBBING ADJUSTABLE LANYARD
Allows the user to be closely attached to the anchorage point on the structure. Easy to
install.
Can be attached on:
9 posts, trees, skylight, ect.: Ø40 à 60 cm
9 beams, chimneys, ect. : diagonal 70 à 150 cm
May be used with the Miller horizontal webbing lifeline. Breaking strength > 18 kN
INSTRUCTIONS FOR USE:
Unfold your adjustable restraining strap so as wind it around the support.
Fit the adjustable restraining strap so that it strangles a horizontal support (Fig. 1) or is attached
to a vertical support. For the latter, provide a stopper to block in the event of slipping. Can be used
up or down (fig. 2)
Lock it by passing one end through the main ring on the adjustable restraining strap that is stran-
gling the structure (Fig. 1)
Apply force to the hanging strap, so as to tighten it around the structure.
You can now attach a line or fall prevention system using a snap hook compliant with standard EN
362. (Fig. 2)..Only one person should be secured on it.
Warning: if the PPE (personal protection equipment) is used above its anchoring point, there may
be risks of product failure, free fall as well as a pendulum effect. Never place the anchor under the
user’s feet but always on top of them. See diagram below (O marking):
Use the second loop for the rescue (Fig. 3) and folow the same instructions as previously.
EN
Fig. 2
Fig.1
Loop to be used for
anchor point
Warning: stop is compulsory
Adjustment loop
Loop to be used only
for rescue
54