PCR191W – Atomic Projection Clock
HOW DO I SET THE TIME ZONE ON MY PCR191W?
Select the US Time Zone by pressing and holding the UP (+) button for 3 seconds.
Keep holding the UP (+) button until the desired US Time Zone (Pacific, Mountain, Central or
Eastern) is highlighted on the display’s US map, located to the right of the time display and above
the seconds.
Release the UP (+) button. The Time Zone is set.
HOW MANY ALARMS CAN BE SET ON MY PCR191W?
The PCR191W has dual alarm with programmable snooze interval. If any of the alarms is
activated, it will sound at the set time and the alarm icon will flash Mondays through Fridays.
HOW TO SET THE TIME ALARM?
Press the MODE button to select the desired alarm to be set – ALARM 1 or ALARM 2. The default
alarm time for ALARM 1 is set to “6:00AM”.
• Press and hold button for three seconds. The hour digit will begin to flash.
• Select the desired hour using DOWN (-) or UP (+) buttons.
• Press button to confirm selected hour and move to minute’s adjustment. The minute digits
will flash.
• Enter the minutes using DOWN (-) or UP (+) buttons.
• Press the button confirming the ALARM 1 time is set.
• Use the same procedure for setting the time for ALARM 2
HOW TO DISABLE THE TIME ALARM?
Press or selecting the ALARM 1 or ALARM 2 – an appropriate bell icon will
disappear from the display showing that alarm is disabled.
HOW DO I SET THE LANGUAGE FOR THE DAY OF THE WEEK?
Press and hold DOWN (-) button until the language abbreviation will be displayed – EN (for
English), SP (for Spanish) or FR (for French). Once the desired language abbreviation is displayed,
release the DOWN (-) button, and the day of the week will be displayed in selected language.
HOW DO I SET 12 OR 24 HOUR TIME FORMAT?
To set 12 hour time format, press UP (+) button once, and “AM” or “PM” will appear to the left of
the time display.
To Next Page
Need help?
General