Preparation
Adapter
Wall
Anchors
Round Head
Screws
Phillips Screwdriver
Standard Screwdriver
Drill and 1/4 in. (6 mm) drill bit
To install you will needIn the box you will find
CR2032
Battery
Wall Plate
Safety
Turn Power OFF
To protect yourself and your equipment, turn off the power at the breaker
box or switch that controls your heating/cooling system.
Before proceeding with the installation, please note the following
safety warnings:
• Always follow the manufacturer’s advice when using
power tools and wear suitable protective equipment (e.g. safety goggles)
when drilling holes, etc.
• Before drilling holes in walls, check for hidden electricity cables and
water pipes. The use of a cable/pipe locator is advisable if in doubt.
To Next Page
Loading...
