Honeywell TH6320ZW2003 - Z-Wave Connection Status Indicators

10
ZWave connection status is located in the
upper-right corner of the screen.
• Thermostat is included and connected to a
ZWave network.
• Thermostat is excluded from a ZWave
network.
• Thermostat is either included in a ZWave
network but the ZWave signal is lost, or
is included but AC power is lost (battery
used as backup). In this case, ZWave
radio is turned off to preserve battery life.
AC power must be restored or you have to
change the power mode. It can be done via
excluding thermostat from ZWave network
and including again in battery power mode
where batteries are used as main power
source. You can check the actual power
mode in the thermostat
MENU/DEVICE INFO.
ZWave connection status
AM
Menu FanMode
Fan
Auto
Mode
Heat
Wake AwayHomeSleep
Following Schedule
Example of Wi-Fi is connected.
Wifi is on and
connected
Wifi is disconnected
or wifi is not setup
Wifi is off
AM
Menu FanMode
Fan
Auto
Mode
Heat
Wake AwayHomeSleep
Following Schedule
Example of Wi-Fi is connected.
Wifi is on and
connected
Wifi is disconnected
or wifi is not setup
Wifi is off
AM
Menu FanMode
Fan
Auto
Mode
Heat
Wake AwayHomeSleep
Following Schedule
Example of Wi-Fi is connected.
Wifi is on and
connected
Wifi is disconnected
or wifi is not setup
Wifi is off
AM
Menu FanMode
Fan
Auto
Mode
Heat
AwayHomeSleep
Following Schedule
Example of thermostat
included and connected in
a
Z-Wave network.