• Place the heater on a firm, level, open surface free from
obstructions and at least 3 feet (0.9m) away from any wall
or any combustible material. DO NOT use on an unstable
surface such as bedding or deep carpeting.
• Fully extend metal stand located on the back of the heater
and route cord through stand.
HEATER SHOULD NOT BE OPERATED WITHOUT THE METAL
STAND PROPERLY POSITIONED.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT
MAY BE TRIPPED OVER BY CHILDREN OR PETS.
SET-UP
• Turn off the heater.
• Allow it to cool for ten minutes.
• Unplug heater and move. This heater is equipped with
a Cool Touch housing for your convenience. Please use
caution when moving as grille area could be hot.
MOVING THE HEATER
OPERATION
• NOTE: While the UberHeat™ Ceramic Heater requires no assembly, the metal stand located
on the back of the unit should be properly positioned before use.
• NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
• The UberHeat™ Ceramic Heater is a portable ceramic heater designed to provide quick,
even heating for personal warmth and whole room heating.
Model HCE200 Series - Manual Ceramic Heater Operation
• With the Power Switch in the OFF ( ) position, plug the heater
into a polarized 120V outlet. DO NOT FORCE THE POLARIZED
PLUG INTO THE OUTLET; it will only fit one way.
• The Power Switch is equipped with two (2) settings, Low
and High. The Low setting ( ) uses 900 watts of power
and the High setting ( ) uses 1500 watts of power. You
can select the proper setting to accommodate your comfort
level with the Power Switch. When you choose any setting
the red Power Light will come on. Because the Low setting
does not require as much electricity to operate, it is more
energy efficient and may be a better option if you are concerned
about the amperage draw on a circuit when the heater is on the
High setting.
3
To Next Page
Loading...
Need help?
General