Honeywell UC100 User Manual

INSTALLATION INSTRUCTIONS
69-1444-5
UC100 Ultraviolet System
Replacement Bulb/Handle Assembly
APPLICATION
The UC100 Ultraviolet System Replacement Bulb/Handle
Assembly is for use with the UV100 Ultraviolet System. See
Table 1 for your model.
INSTALLATION
When Installing this Product…
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
2. Check the rating given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Removal and replacement of the ultraviolet lamps can
easily be done by the homeowner following these
instructions. The homeowner can also call an
experienced service technician.
4. After installation is complete, check out product
operation as provided in these instructions.
CAUTION
Personal Injury Hazard.
Power supply can cause electrical shock.
Disconnect power supply before replacing ultraviolet
bulb(s).
Do not open base unit or lamp handle; there are no
user-serviceable components inside.
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at bulbs while illuminated.
View illumination only through light indicator located
on lamp handle.
To prevent exposure to ultraviolet light, disconnect
power to Ultraviolet System before servicing any part
of heating and air conditioning system.
CAUTION
UV Lamp Burn Hazard.
Harmful to bare skin.
Can cause severe burns.
Disconnect power and wait 15 minutes before
removing ultraviolet bulb(s).
CAUTION
Breakable Glass Hazard.
Can cause personal injury.
Be careful when inserting bulb(s) into lamp base.
Wear protective gloves when handling bulb(s).

Honeywell UC100 Specifications

General

Type	Under Cabinet Light
Light Type	LED
Number of Lights	1
Color Temperature	3000K (Warm White)
Filter Life	Not Applicable
Mounting Type	Under Cabinet
Battery Type	Not Applicable

Summary

Installation Instructions

General Installation Guidance

Read instructions carefully, check product rating, and verify suitability for application before installing.

Personal Injury Hazard Warning

Caution regarding electrical shock hazard from power supply; disconnect power before replacing bulbs.

UV Light Hazard Warning

Warning about harm to skin and eyes from UV light; view illumination only through the indicator.

UV Lamp Burn Hazard Caution

Caution about severe skin burns from UV lamp; disconnect power and wait 15 minutes.

Breakable Glass Hazard Caution

Caution about personal injury from broken glass; handle bulbs carefully with protective gloves.

Bulb Replacement Procedure

Mercury Notice and Cleanup

Information regarding mercury in bulbs, proper disposal, and broken bulb cleanup procedures.

Remove Lamp Bulb

Instructions for rotating the lamp handle counterclockwise to remove the bulb.

Disconnect Bulb from SnapLamp Handle

Guidance on separating the bulb from the SnapLamp handle by pulling straight apart.

Replace Bulb in SnapLamp Handle

Steps for inserting a new bulb into the SnapLamp handle, aligning the notch.

Insert Lamp Handle into Base

Procedure for inserting the lamp handle into the base with the light indicator at the eleven o'clock position.

Finalizing Bulb Replacement

Secure Lamp Handle

Instructions to rotate the lamp handle clockwise until it snaps into place with the light indicator aligned.

Reconnect Power and Calibrate

Reconnect system power and wait ten minutes for SmartLamp models to calibrate airflow sensor.

Verify Bulb Operation

Check that ultraviolet bulbs are operating by viewing only through the lamp light indicator.

Reset Internal Timers

For SmartLamp models, press and hold the reset button for five seconds to reset internal timers.